sealed Crimp & solder connectors

Installation Instructions

BUTT CONNECTOR INSTRUCTIONS 

1. Strip both wires 3/8”
2. Insert wire into barrel
3. Crimp wire to barrel 
4. Heat tubing 
5. Solder flows into barrel 

OTHER CONNECTOR INSTRUCTIONS

1. Strip wire 1/2”
2. Insert wire into barrel
3. Crimp wire to barrel
4. Heat tubing
5. Solder flows into barrel 

For best results: Use heat device of at least 1000°F/538°C. Don’t overheat tubing. Don’t isolate flame. Distribute heat evenly over tubing. Heat until solder flows into wires. To be sold only with installation instructions. 

Unless otherwise stated:  Max. Temp 221°F, 600V Max. building wire, 1000V Max. signs & fixtures, stranded copper conductors only. 

Translate »