sealed solder Thermal Indicator connectors

Features & Benefits

BUTT CONNECTOR INSTRUCTIONS

  1. Strip both wires 3/8”
  2. Intermingle wires 
  3. Center solder over wires
  4. Heat tubing and red dye will form a ring in center of solder sleeve
  5. Continue heating until solder flows into wire strands and red dye disappears from solder sleeve

For best results: Use heat device of at least 1000°F. Don’t overheat tubing. Don’t isolate flame. Distribute heat evenly over tubing. Heat until solder flows into wires and the red dye disappears from solder sleeve. Some red dye may remain in wire strands.

Unless otherwise stated: Rating: 221°F Max., 600V Max. building wire, Stranded copper wire only. Not for multiple wire connections.

Translate »